Contact Us - 01706 521188 We accept Visa and Mastercard We accept American Express We accept Paypal
Lighting Advice
Downlight Insulation Cover Cap SpotClip
  • Staff pick

Downlight Insulation Cover Cap SpotClip

Product-code: SPOTCLIPIII

9 in stock

Ships tomorrow if ordered in the next 17 hours and 27 minutes!

More available in 2-3 days

£3.78 Incl. VAT (£3.15 Excl. VAT)
RRP. £23.69 Save 84%
Downlight insulation cover cap offers an economical solution that allows new or existing downlights to be covered with thermal insulation. more info

Change Quantity

Add to Basket

or
Check out with Checkout with PayPal

Downlight insulation cover cap offers an economical solution that allows new or existing downlights to be covered with thermal insulation. Acting as a barrier between the downlight and the insulation, the SpotClip holds the weight of the insulation and keeps it away from the light.

The SpotClip 3 from Hellermann Tyton is a 3 leg design that is suitable for a large selection of hole sizes and heights. Suitable for hole sizes from 65 to 160mm and heights of up to 130mm. Suitable for use with fire rated and non fire rated downlights.

Specification

  • Suitable for ceiling heights of up to 130mm.
  • For hole sizes of 65-160mm
  • Material: Polyamide 6.6, fiberglass reinforced.
  • Operating temperature: -20 to +120 degrees C.
  • Approved to: EN60659-2-12 / Glow Wire Test 960 degrees C.
  • Can be retrofitted from the room below.
  • Manufacturer: Hellermann Tyton
  • Product code: SPOTLCLIPIII
Product reviews for Downlight Insulation Cover Cap SpotClip (6)
Powered by
5 Stars
3
4 Stars
2
3 Stars
1
2 Stars
0
1 Star
0
Average rating
4.3 / 5
Calculated from 6 reviews
5 out of 6 reviews :

Product used to protect downlights in bathroom ceiling from excess heat build-up under off insulation. Would recommend to tradesmen and DIY ers . Good quality product, easy to install particularly from below.

Did you find this review helpful?

Quality of the product is as expected. Usage; to prevent insulation of touching my downlights.

Did you find this review helpful?

Quality was good

Did you find this review helpful?

Good

Did you find this review helpful?

the little prongs will not hold the cap steady and I didn't get as far as adding the insulation. However a dab of liquid nails on where the three parts touch the upper surface of the plasterboard fixed that. Other than that very good value for money.

Did you find this review helpful?
  • Hole diameter: 65-160mm
  • H (see drawing below): 123-160mm depending on positioning of legs.
  • H2 (see drawing below): 120-160mm depending on positioning of legs.
  • For maximum downlight heights of 130mm. 
  • 3 leg design.

Alternative Products

© 2018 Downlights Direct.
Company Number: 5147452
VAT Number: 846535210
Site by Aesthetic
Top